 |
ChipQuik® Surface Mount Device Removal Kit
This kit is designed to assist engineers in removing SMDs. The Chip Quik method surpasses all others regarding time and money. This method requires no expensive removal equipment or potentially damaging heating guns.
DESCRIPTION
Chip Quik is a specially formulated alloy in wire form designed to melt at the low tem- perature of 136 degrees F, 58 degrees C. It eliminates the potential for damage to the circuit, adjacent components, and the device itself. This method requires no expensive removal equipment or potentially damaging heating guns. The removal process is suprisingly easy. Liquid flux and a soldering iron are used to melt the Chip Quik low temperature alloy that is specially formulated to stay molten long enough to react with existing solder. The SMT device can then be easily removed with a vacuum pen.
FEATURES
- Quickly remove surface mounted devices (SMDs) without expensive rework equipment
- Removes QFPs, PLCCs, SOICs and others SMD chip components under 300 degrees F
- Prevents damage to the PC board, adjacent components, and the device itself
- Complete removal in four easy steps
- Easy clean-up
- Easy instructions provided
DATASHEETS
- Material Safety DataSheet CQ291E
- Material Safety Datasheet CQ08E, CQ16E, CQ32E, CQ123E, CQ4.5E, CQ2000E
- Material Safety DataSheet CQ08ENL, CQ16ENL, CQ32ENL, CQ123ENL, CQ4.5ENL, CQ2000ENL
- CQ123E, CD4.5E, CQ32E and CQ16E Alloys
|
SMD REMOVAL ALLOY & ACCESSORIES |
ET Part# |
Description |
Alloy (4 ft. cut into 6.5" lengths) |
|
| Alloy (16 ft. cut into 6.5" lengths) |
|
| Alloy (32 ft. cut into 6.5" lengths) |
|
| Alloy, No Lead (4 ft. cut into 6.5" lengths) |
|
| Alloy, No Lead (16 ft. cut into 6.5" lengths) |
|
| Alloy, No Lead (32 ft. cut into 6.5" lengths) |
CQ32ENL
 |
| Flux, No Clean (10cc syringe) |
|
| Kit to remove 8 - 10 SMD's, includes 1cc flux, 2.5 feet alloy, alcohol clean-up pads, and instructions |
|
| Lead-free kit to remove 8 - 10 SMD's, includes 1cc flux, 2.5 feet alloy, alcohol clean-up pads, and instructions |
|
|
QUICK AND EASY SMD REMOVAL
1. Apply Low Residue Flux to all the leads on the SMD you're removing
2. With a soldering iron, melt ChipQuik low temperature alloy
3. Easily lift device off the board with a vacuum pen
4. Thoroughly clean site and solder new device to PBC
|
|
